portfoliolkp.blogg.se

Cases sticking in smith and wesson model 18
Cases sticking in smith and wesson model 18










I setup an MP 2.0 5" with a Streamlight VIR II, a Tru Glo tritium front sight, and a DeltaPoint Micro which is pretty nice at the range. Using the aperture as a ghost ring backup sight with the front iron sight in the lower 1/3 is pretty effective too, so you get a red dot and backup irons with no slide modifications, which is a pretty good deal. If you can shoot with iron sights and find them alright already, then the deltapoint micro is easy to adapt to. Be thankful that some scrub made this post and hopefully it's searchable via google/duckduckgo for others in the future. Wish Leupold had documented what to do if one has over tightened the battery cover in the manual.Screw the battery cover back in don't tighten it too much this time :p. Note that the rubber control circuit board cover part has a specific orientation in which it must go (line up the slot with the protrusion). Reassemble the battery cover control circuit board and rubber button part of the battery cover.Use that bar as a screwdriver to remove the battery cover. Observe there are 2 cutouts in the battery holder place around the rim that keeps the control circuit board in place.Place the cover and the circuit board aside for later reassembly. You should be able to do this without scratching anything visible to the user or damaging the rubber.

cases sticking in smith and wesson model 18

Take note of the orientation of the pogo pins on the metal contacts. Using your fingers or a small flat head screwdriver, pry off the rubber cover holding down the control circuit board.Do all the safety things (clear the gun, lock the slide back, make sure there is no magazine inserted, and keep it pointed in a safe direction throughout all additional steps).That said, if you do tighten it down too much, and you've googled for a solution (after this post has been made anyway) do the following (instead of getting out the vice grips). PSA: Don't tighten the battery compartment screw too much we all know that you have to take off the cover to remove the slide.

cases sticking in smith and wesson model 18

Smith & Wesson related news, photos, reviews, questions, accessories and tech.Ĭommerce or political content are not permitted and should be discussed in the appropriate subreddits for them.Ĭome join The Gun Network, a collection of all gun-related sub-reddits!












Cases sticking in smith and wesson model 18